Plastic SoCket Mould need to know when using

Comments · 32 Views

plastic socket mould https://www.tangrammould.com/Five-Pin-Multipal-Socket-Mould.html

Plastic Socket Mould is one of the many connectors. It is a connection method often used on the PCB board of electronic products. When using different PCB boards, the corresponding requirements of electronic products and equipment should be selected. Generally speaking, the available space of size and electronic equipment is the focus of consideration, because generally, the smaller the size, the smaller the distance between the contact, the higher the density of the contact. Such a close contact design generally means less insulation and lower force, so when you buy or use, you should know the following product knowledge;

Plastic socket more

1. The first thing to consider when buying is whether the purchased voltage and current requirements can be met. You must know whether the connector product is used for low -level circuits or power circuits. Because there is no current, it cannot work, so you need to choose contact with the coating when you buy, because it cannot penetrate the oxidation layer under small current and low voltage.

2. When the general enterprise needs to purchase Plastic Socket Mould, general enterprises are recommended to choose high temperature resistance, because electronic products will generate working temperature during use. If you choose high -temperature resistance in the production of electronic products, you can reduce the adverse effects under high temperature conditions. If it is used to resist high -temperature connectors, it will be unbearable when the working temperature is too high, which may cause the connector or electronic PCB board to burn and affect the use of electronic products.

Plastic socket more

3. If the number of electronic equipment products produced is small, the number of insertion times is small, and the low -cost ordinary contacts can be considered. Because contact pressure is an important indicator of the connector. If the contact pressure is large, it means that the greater interpolation and pulling force directly affect the wear of the contact resistance and contact parts.

4. Do not frequently insert the Plastic Socket Mould that has been fixed on the PCB board, because if the connector end and other components such as the connector end are worn to a certain degree, when this wear reaches a certain wear resistance, the mechanical life will be reduced. It affects the service life.

plastic socket mould https://www.tangrammould.com/Five-Pin-Multipal-Socket-Mould.html

Comments